Overview
A DC to DC charger and a second battery look after the power side of a modern dual battery setup. Neither talks to the car, so the dash still reports the battery control module as missing. In Emulate mode, SmartR230 covers that on the CAN-B bus.
How it works
Normal running
The diagram is simplified. Always follow the charger manufacturer's installation manual for cable sizes and fuse ratings.
Charger options
| Model | Victron Orion XS 12/12-50A | Proven |
|---|---|---|
| Output current | 50 A | More headroom for a larger battery. |
| Isolation | Non-isolated | Shares a common negative with the car. |
| Fuse and cable | Size to the charger | Take the rating and cable gauge from the Victron manual for your model. |
Why we recommend Victron
Victron Energy is an established maker of battery charging and power systems, and its DC to DC chargers are built for exactly this job: charging one battery from another, and from the alternator, at the correct voltage. They are also designed to protect the starter battery from any parasitic current draw by the consumer battery, which makes this a well proven solution. Using a proven product from a known manufacturer means you are not relying on an unbranded unit of unknown quality sitting next to your batteries.
The Orion XS is slim, which suits the R230 well. It fits neatly where the factory battery control module used to sit, so you do not need to find a new mounting spot or run long cables across the car.
It also connects over Bluetooth to Victron's app, which gives you real insight into what your batteries are doing. You can see voltages and charge rates as they happen, and review history such as the current drawn over time. That makes it much easier to confirm the system is healthy, or to track down a drain.
You also get the reassurance that comes with a recognised brand: published specifications and manuals, a manufacturer warranty, and a support network if something goes wrong. Check the warranty terms with the retailer you buy from.
See the Orion XS on Victron's website
Other chargers are worth considering
Victron is our recommended choice, not the only one. Other DC to DC chargers have been fitted by R230 owners, and SmartR230 works alongside any of them because it only handles the CAN-B side. SmartR230 is an independent product and is not affiliated with Victron Energy.
Who does what
DC to DC charger
Keeps the starter battery charged from the bus at the right voltage. It replaces the factory battery control module and says nothing on the CAN bus.
Emergency switch
Normally off. If the consumer battery goes flat, switch it on to tie the starter battery to the bus so the modules and CAN-B stay powered while you start the engine.
SmartR230
Sends the signals the car expects from the missing module, so the fault codes and the "battery fault, visit workshop" warning stay off. It never carries charging current.
Planning your install
The charging wiring and SmartR230 are fitted separately. Either order works.
- Fit a fuse close to each battery positive, sized for the charger you choose.
- Mount the emergency switch where you can reach it, and leave it off in normal use.
- Use the install guide to connect SmartR230 to CAN-B. The charger wiring is separate.
- SmartR230 has its own Wi-Fi web page you can open from your phone. It shows whether the car is going to sleep, which helps when diagnosing battery drain, and it shows your car's VIN. It can also set your dashboard clock from your phone, and its low-power standby design keeps parasitic drain minimal.
Pair it with SmartR230
Your charger looks after the batteries. SmartR230 keeps the dash clean.